What is fill dirt, and how much do you need?
By Ali (not a contractor)Updated
Fill dirt is subsoil, the mineral layer dug from below the topsoil, sold by the cubic yard to raise, level or backfill ground. It has little organic matter, so it packs down firm and does not rot away. A yard of it weighs about 1.2 tons (1.0 to 1.5) and costs about $20 a yard, or $17 a ton, before delivery. Those are national typical prices, and yours will differ with your region and haul distance.
What fill dirt is
Fill dirt comes from digging: a basement, a pond, a road cut. Whatever sits under the top few inches of soil gets hauled off and sold. That is usually clay, silt, sand or a mix, with some stones and roots in it. Hunker says fill dirt often has rocks, roots and large clay clumps in it, and that screened fill, certified free of most debris, costs more.
Low organic matter is the whole point. Leaves, roots and compost in the soil break down over time, and the ground sinks as they go. Subsoil has little left to rot, so a pad of it stays where you put it. The flip side is that it grows very little. New home sites often have the topsoil stripped off and the lawn is started on subsoil. University of Maryland Extension suggests adding compost when a soil test shows less than 3 percent organic matter.
Types of fill dirt
Common fill costs $5 to $15 a yard, clean fill $10 to $25 and select or structural fill $15 to $30. Names vary by supplier. Ask what is in the pile before you order.
| Type | What it is and where it goes | Per yard |
|---|---|---|
| Common fill (fill dirt) | Unscreened subsoil that may hold stones and roots. For low spots, berms and big holes. | $5 to $15 |
| Clean fill | Fill free of trash, wood, metal and other debris. For yard grading and backfill. | $10 to $25 |
| Select or structural fill | Tested, screened soil that compacts to a set density. For under slabs, driveways and footings. | $15 to $30 |
| Fill sand | Sand that drains freely and compacts less tightly. For wet spots, pipes and paver bases. | $15 to $40 |
The first three price ranges are where HomeGuide and Hello Gravel agree. Fill sand is this site’s range ($28 typical). Structural fill is the one case where paper matters: if an inspector will sign off on a foundation, the soil may need a soil engineer’s report, and HomeGuide notes that fill without that certification is only good for general landscaping. For a yard, common or clean fill is normally enough.
Screened versus unscreened is the other choice. Unscreened is cheaper and rougher. If a lawn, a path or a patio will sit on it, ask for screened, because stones and clumps leave voids that settle later.
Fill dirt vs topsoil
Fill goes under, topsoil goes on top. Fill gives you a solid, stable base and raises the level cheaply. Topsoil is the planting layer: more organic matter, more nutrients, less stable. Cleanfill.net rates clean fill “excellent” for compaction and topsoil “poor”.
Prices follow the same split: topsoil is about $25 a yard (range $10 to $50), against $20 for fill dirt.
For a lawn, put 4 to 6 inches of topsoil over the fill. HomeGuide gives 4 to 6 inches for a new lawn, the same range as this site’s new-lawn preset, and the garden-bed preset runs 6 to 12 inches. HomeGuide also suggests loosening the top of the fill before spreading topsoil, so the two layers blend and water does not stall at the line between them. Do not pile soil over tree roots: UMD Extension warns that small changes in soil depth over roots can contribute to tree decline.
What a yard weighs and costs
Prices checked: Oct 2026.
| Item | Fill dirt | Topsoil | Fill sand |
|---|---|---|---|
| Tons per yard | 1.2 (1.0 to 1.5) | 1.1 (0.9 to 1.4) | 1.4 (1.2 to 1.5) |
| Price per yard | $20 ($5 to $45) | $25 ($10 to $50) | $28 ($15 to $40) |
| Price per ton | $17 ($4 to $23) | no ton price | $20 ($10 to $30) |
| Delivery | $70 ($30 to $150) | $70 ($30 to $150) | $75 ($0 to $150) |
Wet fill weighs more than dry. Most fill dirt runs near 90 pounds a cubic foot, which is 1.2 tons a yard, and a yard is 27 cubic feet. Convert between the two with the cubic yards to tons calculator. If your supplier sells by the ton, wet dirt costs more per yard, because the water is weighed too.
A load is what the truck carries, not a fixed size. A tandem dump truck can legally haul about 14 tons, which is about 11 to 12 yards of fill dirt at 1.2 tons a yard. At typical prices, 12 yards is about $240 for the dirt plus about $70 delivery, near $310. A tri-axle carries 16 to 25 tons, so it takes a larger order in one trip. The dump truck guide shows loads by material.
How much fill dirt you need
Length times width times depth in feet gives cubic feet. Divide by 27 for cubic yards. One yard spread 3 inches deep covers about 108 square feet (27 cu ft divided by 0.25 ft), and at 6 inches it covers 54.
Then add for settling. Loose dirt from a truck is full of air, and rain and compaction squeeze it out. How much it drops depends on your soil, so allow extra. The topsoil and fill dirt calculator adds 15 percent for fill dirt (10 percent for topsoil) and rounds the order up to the next half yard.
Compaction: build it in lifts
Dump the whole depth at once and the top feels firm while the bottom stays loose. Spread and pack in lifts instead. Allan Block, a retaining wall maker, says layers thicker than 8 inches give “less than adequate soil strength”, and Hello Gravel suggests 6 to 8 inch lifts for structural fill. Engineered jobs also test density: Allan Block asks for 95 percent of Standard Proctor, meaning 95 percent of the most the soil can be packed at its best moisture.
At home you will not run density tests. Do the practical version: lift by lift, with the soil neither bone dry nor soaked (Allan Block notes soil that is too dry or too wet will not reach full density), and tamp or roll each layer. A fill 6 inches deep or less fits in one lift.
Worked example: raise a 20 x 30 ft low spot 6 inches, then add 4 inches of topsoil
Fill layer, 6 inches (0.5 ft) deep:
- 20 x 30 x 0.5 = 300 cubic feet, which is 300 / 27 = 11.1 cubic yards.
- Add 15 percent for settling: 11.1 x 1.15 = 12.8 yards. Order 13.
- Weight: 12.8 yards x 1.2 tons = about 15.3 tons. That is a little over a tandem’s 14 tons, so a tri-axle (16 to 25 tons) brings it in one load, while a tandem makes two trips and two delivery fees.
- Cost: 13 yards x $20 = $260, plus about $70 for one tri-axle delivery.
Topsoil cap, 4 inches (0.33 ft) deep:
- 20 x 30 x (4 / 12) = 200 cubic feet, or 7.4 cubic yards.
- Add 10 percent for settling: 7.4 x 1.1 = 8.15 yards. Order 8.5.
- Weight: 8.15 yards x 1.1 tons = about 9.0 tons.
- Cost: 8.5 yards x $25 = about $213, plus about $70 delivery.
Total, with one fill delivery and one topsoil delivery: 260 + 70 + 213 + 70, about $610. The 6 inches of fill and 4 inches of topsoil together raise the ground 10 inches, so check that this does not bury siding, a vent or a tree trunk. Keep the finished grade sloping away from the house, about 1 to 2 percent (UMD Extension: a drop of 1 1/4 to 2 1/2 inches every 10 feet).
To run your own numbers, enter the length, width and depth in the topsoil calculator, pick fill dirt, then run it again with topsoil for the cap. The cubic yard calculator handles odd shapes, and the sand calculator covers fill sand.
Fill dirt, clean fill and fill sand, quick answers
Fill soil is the same thing as fill dirt. Clean fill is fill dirt with no trash or debris, though the label is not standardized. Select fill is screened and tested to a specification. Fill sand is a different material: it drains and compacts less tightly, so it suits wet spots, pipe trenches and paver bases rather than load-bearing pads.